Flyzone FLZA2000 Manual do Utilizador

ASSEMBLE ONLY WITH ADULT SUPERVISIONPlease read through this instruction booklet to THOROUGHLY familiarize yourself with the assembly and flight chara

107. Add a small amount of foam-safe CA to the previously cut seam and close the fuselage halves, being sure not to bind the tail control linkages.8.

11PROBLEM CAUSE/SOLUTIONFor any other problems not addressed here, please contact Product Support.The power LED on thetransmitter does notilluminate w

2PRECAUTIONSYour Playmate should not be considered a toy, but rather a sophisticated, working model that functions very much like a full-size airplane

3GLOSSARY• Lithium Polymer (LiPo) Battery: Rechargeable battery which is used to power the airplane. LiPo batteries are lighter and smaller than most

42. With the power switch on the transmitter set to “OFF”, connect the battery to the charge port inside the charging compartment.3. If the battery is

5during fl ight. NOTE: Always stay clear of the propeller when the battery is plugged into the airplane!CHECK THE CONTROL DIRECTIONS1. When the right c

64. If the elevator does not move in the correct direction according to step #1, you can reverse its movement by pressing and holding either elevator

7transmitter will make a continuous fast beeping), the bends in the pushrods can be adjusted to “mechanically” change the trim of the control surfaces

85. Just before landing, at about 1 foot [0.3m] above the ground, move the throttle control stick all the way down and apply some up elevator (right c

93. If the spring is still attached to the propeller, carefully remove it from the propeller. Do not stretch the spring. If you no longer have the spr